Two ways to convert your kitchen cabinets or pantry to plastic cabinet drawers
OUR SLIDE-OUT CABINET DRAWERS
“Simplicity – the ultimate design”
When we started the design of our roll out Cabinet Drawers, we had 4 goals in mind:
- The slide-out cabinet drawers must look elegant. Out plastic cabinet drawers provide a true sense of elegance.
- It must be durable…capable of holding about 100 lbs
- It must be dead easy to install
- It had to be mass-produced to keep the cost (and price to U) as low as possible
Here’s what we came up with:
- A simple curved-front-face drawer that comes in one color only – white – and looks elegant in any cabinet setting.
- Drawer Material – High Impact, Kitchen Grade Polypropylene (a type of plastic) reinforced with fiberglass & steel.
- A patented design base to hold the drawer and a key component for easy installation. See EXTREMELY IMPORTANT below to see why.
- 3/4 Extension Guides Only (Rails, Slides). See our explanation of why: Why 3/4 Extension?
- Load Capacity -100 lbs
- Recommended maximum Load – 60 lbs.
- Designed to fit kitchen base cabinets that are 22″ deep. All drawers are 21 5/8″ long and 3″ high – only the width varies.
- Only 5 standard widths…11”-14”-15”-17”& 20”…no custom widths.
- US Patent No.- US 6,659,576 B1
- Steel Reinforced Bottom
11″, 14″, & 15″- Single ‘H’ (see picture)
17′ & 20″- Double ‘H’
Nylon Roller Detail – Base Front
Plastic Cabinet Drawer Loaded With 50 lbs…4 cases of cola is a lot of weight!
EXTREMELY IMPORTANT
The cabinet drawer comes with a one-piece, pre-assembled, factory-aligned base which makes the installation a snap. Drawer rails come in sets an outer set that normally fastens to the cabinet walls and an inner set that fastens to the drawer. The two sets have to interlock to fairly tight tolerances too loose and the drawer will not hold much weight. Too tight and the drawer will jam. If you are trying to install rollouts in your existing cabinets the conventional way (outer rails attached to cabinet walls)…Not only are you working in a cramped, dark space…You have to shim the outer rails to match the drawer rails.
Our design solves this problem by making a one-piece, pre-assembled, factory-aligned base…Designed to hold the outer rails at exactly the right distance for easy rolling…No finicky shimming…All you do is screw the base into your existing shelf…Place the drawer in the base…And bingo! You have a roll-out drawer where you used to have a shelf. It’s that easy!
Some of our competitors have similar products that screw to a shelf. To avoid our patent, they give you 4 angle irons…2 per side…And instruct you to install one side…And then tell you to align the other side…Putting the alignment problem on you. Our one-piece, pre-assembled, factory-aligned base eliminates alignment problems for you. Just put the base on your shelf…Put in 4 screws…Pop in the drawer…And it works perfectly every time. To see just how easy the installation is watch this 2-minute video…Installation
